Miter Joint Shrinkage Explanation

Im sure everyone has seen a miter joint that has opened up similar to the one in this image. Id like to explain why this type of miter joint shrinkage happens so that you can try to avoid this unsightly problem.

To understand this problem you first need to take a minute to understand how wood is structured. Its easiest to think of wood being composed of lots of very small tubes all tightly packed together. Those tubes run parallel to the direction of the grain.

As you can see in the diagram the cross section of wood resembles a bunch of straws with the pores running in the direction of the grain.

Now, those pores are filled with water, the moisture content of the wood changes depending on the time of year and the relative humidity. When wood drys out the tubes get narrower and thus cause shrinkage in the cross grain direction. There is very little shrinkage along the direction of grain. The straws dont get shorter but they do get narrower.

So now take the fact that most of the shrinkage occurs in the cross grain direction and look at the picture of the miter joint. The tip or toe of the miter joint is very narrow in the cross grain direction. The heal of the miter has the full width of the board in the cross grain direction. Therefore, as things dry out there is more total shrinkage at the heal of the joint. Very little shrinkage will occur at the toe of the joint. In addition, there will be little to no movement in the longitudinal direction (along the grain).

Obviously miter joints cant be eliminated for trim with profiles. However, trim material thats flat stock is best joined at a corner with the butt and pass method. The butt and pass method will all but eliminate seasonal movement of the joint. To see how I like to do butt and pass trim using pocket screws check out my article: . If you must use a trim material with a profile then make sure your wood is acclimated to the surrounding humidity levels and try to prevent large changes in humidity within the house.

You can also use a biscuit joiner to structurally reinforce miter joints to help prevent joint shrinkage.

Leave a comment if you think your Facebook Friends would find this article useful. Thanks in advance!

Similar Posts:

• Exterior Caulking Tips
• ink on paper.
• The Cross Boutique London
• NewspaperWood: Incredible Furnishings and Products Made From Recycled Newspaper
• Which is the Tastiest Strawberry?

Tags: Joint Shrinkage, Miter Joint, Miter Joint Shrinkage, Shrinkage   Posted in Gardening Consultant